Washer Bearings

Drum Bearing Slide - Green (Sold individually)

1 Review

Part Number: WE1M1067

This single green drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum won?t tumble you many need to replace the slides. The manufacturer recommends replacing both slides at the same time. There are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect the power to the dryer before starting your repair.

Washer Tub Bearing, Rear

Part Number: MAP61913707

This tub bearing is for washers. Tub bearing supports the spin basket shaft at the tub. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands.

Tub Bearing

1 Review

Part Number: WH2X1198

This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you may need to replace the tub bearing. This bearing is made of metal, and is approximately 3 inches wide and 2 inches tall.

Split Ring

1 Review

Part Number: WH02X10265

This split ring is two inches in diameter.

Tub Bearing Washer

Part Number: WH2X1197

The tub bearing washer goes between the transmission and the tub bearing in your washer. This part helps to keep the inner tub spinning smoothly during operation. If your washer is noisy you may hear the bearing wearing on the transmission and the tub bearing washer will need to be replaced. This part is gray in color and measures approximately 2” in diameter. This is a genuine OEM part. Please disconnect the power and water supply to the washer before starting this repair.

Transmission Pulley and Bearing Kit

Part Number: 12002213

The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.

Tub Seal and Bearing Kit

3 Reviews

Part Number: W10435302

This kit includes the shaft, 3 bearings, seals , grease, adhesive and the spanner nut, which is NOT sold separately. Also may require a bearing driver tool to install. PS3503307

Spin Tube Bearing

Part Number: WP8546462

This spin tube T-Bearing is an inch long. Sold individually.

Spin Bearing

1 Review

Part Number: 3204405

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Ring, Thrust

Part Number: WP62658