Washer Hoses and Tubes

Drain Hose

10 Reviews

Part Number: WH41X10096

This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.

Washer Drain Hose

1 Review

Part Number: W11244231

The drain hose carries used water from the washer to your house drain.

Washer Hose with Bellows

5 Reviews

Part Number: 4738ER1004B

This washer hose with bellows, also known as a dispenser hose, is a genuine OEM replacement part for your washer. Replacing this part can be helpful if your washer is leaking. The dispenser hose connects the dispenser assembly to the tub. Before beginning the repair, unplug the washer and turn off the water supply. You will need a Phillips head screwdriver to complete this repair; a clamp tool can also be helpful. Remove the screws holding the lid of the washer in place, and take off the lid. Locate the dispenser hose and remove its clamps. Place the clamps on the new hose, using the arrows for a guide in positioning the clamps. Install the new hose and reassemble all other parts.

Rubber Injector Valve

1 Review

Part Number: WP216201

This rubber injector valve is commonly known to cause a leak at the top left corner of the outer tub. It fits over the injector nozzle. This part helps control the water flow rate from the fill valve to the tub. If your washer is leaking you may need to replace this part. This injector valve is a genuine OEM part. Please remember to disconnect power to your washer before starting your repair.

Tub-to-Pump Drain Hose

Part Number: 4738ER1002A

This hose has bellows to allow for flexibility during the wash and spin cycles.

HOSE ASSEMBLY,DRAIN

1 Review

Part Number: AEM73732901

Tub-to-Pump Hose

3 Reviews

Part Number: AEM73213001

Plastic Injector Nozzle

Part Number: WP213015

This injector nozzle is just under three inches long. It is white in color and made entirely of plastic.

Hose Assembly,Drain

Part Number: 5215ER2002G

Drain Hose

5 Reviews

Part Number: WPW10358149

It connects from the pump to the back panel. The clamp is not included.