Washer Seals and Gaskets

Washer Door Boot Seal

4 Reviews

Part Number: 5304505004

This is a door boot, also known as a door gasket or door bellows, for various models of washing machines. This door boot is used to seal the inner drum of the washing machine from the inside of the washing machine cabinet, and the outside of the appliance itself. If you are noticing soap or water leaks, or if the inner drum of your washer is significantly loose and/or showing signs of tearing, this boot will need to be replaced. To remove this boot, you will need a set of pliers to remove its clamp. This boot is sold as an individual OEM part, so any necessary clamps or parts to secure it are sold separately.

Front Load Washer Bellow

3 Reviews

Part Number: W11106747

Centerpost Gasket

1 Review

Part Number: W10814296

Also known as Main Outer Tub Seal. This part helps to prevent leaking from the bottom of the tub.

Door Boot Seal

Part Number: MDS47123602

This door boot seal is for front loading washing machines. This part forms a seal between the wash tub and the door, preventing leaks. We recommend unplugging the washer before installing this part and wearing work gloves to protect your hands.

GASKET

1 Review

Part Number: MDS66290801

Front Upper Felt Seal with Adhesive

Part Number: 5303937182

The upper felt seal for your dryer is attached to the top edge of the drum support area, and is held there by a high temperature adhesive. It creates a seal where the dryer door opens and closes, so that heat remains in the dryer while it tumbles. If your old upper felt seal is coming apart, you notice that hot air is leaking out the dryer door, or your clothes are taking too long to dry, you may need to replace the seal. When you order this part, it comes with the upper felt seal, as well as the required high-temperature adhesive.

Tub Seal

2 Reviews

Part Number: WH02X10383

The tub seal helps prevent any leaking around the transmission of your washer outer tub. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. It is suggested to have it installed by a qualified technician because the seal can be difficult to replace. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Bellow

Part Number: W11314648

This genuine OEM door bellow, also known as a door boot seal, is sourced directly from the manufacturer for use in front load washing machines. It is a flexible rubber seal that is found around the opening of the washer door. It is responsible for creating a watertight seal between the door and tub during the wash cycle. It also absorbs vibrations and reduces noise while the washer is running. If the seal is torn, worn down or no longer able to remain securely attached to the washer frame it will need to be replaced promptly. A faulty seal will result in water and detergent leakage and potential injury as well as increased noise from the washer.

Washer Door Boot Seal

5 Reviews

Part Number: 4986ER0004F

Also known as a door boot seal or bellow and comes with a drain hole. Door boot 4986ER0004F is an original equipment manufacturer (OEM) part that fits some front-load washers in these series: Kenmore and Kenmore Elite 796; and LG WM and CW. Door boot 4986ER0004F forms a seal between the wash tub and the door, preventing leaks. This door boot includes a drain port; if your 27-inch LG front-load washer was made before September 2007, use door boot 4986ER0004B instead, because those washers don't have a drain port.

Front Load Washer Bellow Door Boot Seal - Gray

2 Reviews

Part Number: WPW10381562