1-877-910-4614
Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
Search by part or model number
The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.
Easy Part #:
EAP11738697
Availability:
In Stock
Your price
$5.73
The float is used to help monitor the water level inside of the dehumidifier bucket to prevent water from overflowing onto the floor. Once the water level reaches the maximum in the bucket, the float will signal the float switch to shut down the dehumidifier to avoid the bucket from overflowing, causing water to spill on to your floor. If your bucket is overflowing you may need to replace the float. The float is black in color, made of plastic and measures approximately 4” long. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.
EAP11738360
The bucket water level switch is used to shut the dehumidifier off to prevent water overflow when the water bucket gets full. If your dehumidifier will not run and the bucket is empty, you may need to replace the switch. This is a genuine OEM part. Please make sure you unplug the dehumidifier before starting your repair.
EAP992307
$56.66
The dehumidifier humidistat control, also known as a humidity controller, can sense the humidity level and will shut off the dehumidifier once the humidity level drops to a certain level. The humidistat control will need to be replaced if the dehumidifier won't shut off. Please remember to disconnect the power to the dehumidifier when starting your repair. This is a genuine OEM part.
EAP11738359
$48.60
The capacitor works in conjunction with your dehumidifier by helping to start the compressor motor. The capacitor attaches to the dehumidifier motor and helps start up the motor. If the dehumidifier compressor continues to trip or doesn’t run the part may be defective and will need to be replaced. This capacitor is 15 MFD and is 300 volts. Please remember to disconnect the power before starting the repair. This is a genuine OEM part.
EAP11738454
Special Order
$51.47
EAP11738449
$34.34
Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.
EAP11739983
$50.51
Below are the most popular Whirlpool Dehumidifier models we have.