Opening the cabinet of a newer Whirlpool model | Note: | | Disconnect the power source to your dryer before you begin to open its cabinet. Either unplug the unit from the wall outlet, remove the appropriate fuse from the fuse box, or flip the appropriate breaker in the circuit breaker panel. | Opening the cabinet for newer Whirlpool brand models starts at the control panel. Begin by removing the end caps found at either end of the console. Lift them from the back, and then pull them towards you. There will be two screws holding the console in place. Remove the screws, and then slide the console towards you and flip it up. You will find an additional three screws at the back of the cabinet top. Remove these and slide the cabinet top towards you and lift it off the unit. Proceed by removing the kickplate. There are two spring catches that need to be disengaged before you can remove the kickplate. Each spring catch is found about four inches in from each side. Use a putty knife or some other thin and flat object to wedge in between the front panel and the kickplate. Push down on the clips with the putty knife to disengage. Open the dryer door and remove the screws that are holding the hinges to the door. Tilt the door up and pull on it gently to remove it. Continue the dismantling process by removing all the screws you find that are holding the front panel to the unit. There will be door switch screws, ground wire screws, and other screws holding the front panel to the bulkhead. Reassembling the entire unit is basically the disassembly process in reverse. Replace the front panel of your dryer. Replace the dryer door, and then replace the kickplate. Reattach the cabinet top and then push the control panel back in place and reattach the two end caps. |