Frigidaire Dishwasher 1071-003A
Repairing your 1071-003A Frigidaire Dishwasher is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
1071-003A model diagrams below. Trust us to help you find the part you need and get your
1071-003A Frigidaire Dishwasher running again.
Diagrams for Frigidaire 1071-003A Dishwasher
There are 11 diagrams for 1071-003A. Click on the diagram where you think your part is located.
Most Popular 1071-003A Parts
These are the most commonly purchased repair parts for 1071-003A.
-
This is sold individually. Please order quantity required.
-
(2)
The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.
-
(1)
This wheel and axle assembly is located on the lower dishwasher rack to allow you to roll the rack in and out easily. They are sold individually and eight are usually required for your model. This part is white in color, made of plastic and is sold individually. This is a genuine OEM part.
-
NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.
-
This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into specific groups. This silverware holder is made entirely of plastic with a crisscross pattern allowing water and small food particles to pass through it during the cleaning process. This model is grey and roughly 14 inches long, about 6 inches high, and almost 4 inches thick.
-
Sold individually.