Most Popular Parts
These are the most commonly purchased repair parts for 80012.
-
(3)
The grease filter works in conjunction with microwaves and is used to help collect grease particles in the air from cooking. The grease filter is chrome in color and measures 7 3/4” L x 5” W. This grease filter is sold individually. Most microwaves require two filters, please check your model for correct quantity needed before ordering. This is a genuine OEM grease filte
-
(6)
This 30 watt 120 volt incandescent light bulb, with a small screw base is used to light up the surface below your microwave or brighten the interior of the microwave once the door has been opened. If your light bulb is burnt out it will need to be replaced. Before you change the bulb, be sure to check that the light socket still works, as it may need to be replaced as well. Remember to disconnect the power to the microwave before you begin this repair. This is a genuine OEM part and is sold individually.
-
(3)
The charcoal filter is used to remove cooking odors from that air that circulates through the vent. It measures approximately 73/4-inch by3/4-inch and is sold individually. This is a genuine OEM part.
-
This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.
-
This line fuse protects the microwave by shutting down if there is an electrical surge. If your microwave is not turning on, you may need to replace the fuse. This part is just over an inch long, metallic on both ends and white ceramic in the middle. Please remember to disconnect power to your microwave before starting your repair. This is a genuine OEM part.
-
(1)
The vent damper is used to close off the exhaust duct when the fan is not running, to prevent outside air from entering the microwave. When the fan turns on it allows air to vent away from the microwave. The damper measures approximately 10-inch long by 3-inchwide and is a genuine OEM part.