Admiral Wall Oven A59FN-5TVW-R
Repairing your A59FN-5TVW-R Admiral Wall Oven is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
A59FN-5TVW-R model diagrams below. Trust us to help you find the part you need and get your
A59FN-5TVW-R Admiral Wall Oven running again.
Diagrams for Admiral A59FN-5TVW-R Wall Oven
There are 4 diagrams for A59FN-5TVW-R. Click on the diagram where you think your part is located.
Most Popular A59FN-5TVW-R Parts
These are the most commonly purchased repair parts for A59FN-5TVW-R.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(2)
The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.
-
(2)
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2-inch x 12-3/4-inch x 16-3/4-inch and is a genuine OEM part.
-
The clock knob allows you to adjust the clock located in the control panel section of your range. This clock knob is less than an inch long, black in color, made of plastic and is sold individually. This genuine OEM knob will accept a D shaped shaft.
-
(1)
This spade style bake element with push on wire terminals is 15 inches long and 19 inches wide. The depth of the terminals is three inches.