Most Popular Parts
These are the most commonly purchased repair parts for ADG6HRYS117TW01.
-
(7)
This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.
-
The retaining clip goes onto the end of the roller axle and holds the rear wheel onto the axle. If the ring is broken, damaged, making noises, or will not tumble, you will need to replace it. This is a genuine OEM part and is sold individually.
-
This spring retaining clip is used to hold the front panel onto the top of the washer. If your front panel is loose you might need to replace the clip. The clip is made entirely of metal and is used for some washing machines. This part is not quite an inch long and is sold individually. This is a genuine OEM part.
-
(2)
Sold individually. This bulb is a 7 watt appliance incandescent light bulb.This appliance light bulb is two inches long. It is used for many clothes dryers.
-
