Admiral Washer AW25K3H Sections

There are 9 diagrams for AW25K3H. Click on the diagram where you think your part is located.

BASE & DRIVE (REV. A - D)

BASE & DRIVE (REV. E - J)

CONTROL PANEL (REV. A - D)

CONTROL PANEL (REV. E - J)

TRANSMISSION (REV. A - D)

TRANSMISSION (REV. E - J)

TUB (REV. A - D)

TUB (REV. E - J)

WATER CARRYING & PUMP ASSY. (R…

Most Popular Parts

These are the most commonly purchased repair parts for AW25K3H.

Screw, 8/18 x 3/8

$7.40

In Stock

This screw is sold individually.
Spray Paint - 12 oz. - White

$18.90

In Stock

(1)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
Screw

$12.18

In Stock

This screw is sold individually.
Drain Pump with Pulley

$71.42

In Stock

(2)

This drain pump with pulley has 2 ports. The pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking or has a burning smell, you may need to replace the drain pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
Transmission Lower Lip Seal Repair Kit

$19.93

In Stock

This transmission lip seal repair kit comes in two pieces: a red four inch long piece, and a black one inch long piece. Both pieces are made entirely of plastic. This repair kit comes with and instructions sheet and it is used for some washing machines.
Transmission Pulley and Bearing Kit

$48.94

In Stock

The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.