Most Popular Parts
These are the most commonly purchased repair parts for CGL1120ADL.
-
This screw is sold individually.
-
(2)
This part is used to support and keep your range level. You can adjust the height of the leveling leg to help level your range. The leveling leg is black in color and made of plastic. The manufacture has updated this part from the original. This part now measures approximately 1.859" and sold individually. This part is a genuine OEM part. This leg may be shorter than the original but is the factory replacement. Longer leg is not available.
-
This clip is used to secure the thermostat bulb. They are sold individually.
-
(10)
The flat style gas oven igniter is used to ignite the gas to light the oven burner, which produces heat for your range. If the element has shorted out, is no longer glowing, or is glowing but only orange or red rather than white, then you will need to replace the oven igniter. When replacing the igniter please be very careful not to touch the gray element part of the igniter as it is very fragile. The igniter measures approximately 3-3/4"in length and the amperage range is 3.3 to 3.6. This igniter kit can replace igniters for either the broil or bake burners and can replace shorter and longer igniters. The kit includes the igniter, 4 wire nuts, insulation, 2 wire assembly and a bracket. This is a genuine OEM part. Please make sure to disconnect the power and shut off the gas supply before starting your repair.
-
(2)
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2-inch x 12-3/4-inch x 16-3/4-inch and is a genuine OEM part.
-
This gas valve knob is two inches in diameter. It is black in color with white lettering denoting the off, high, and light positions. Made entirely of plastic, this knob will accept a 'D' shaped shaft.