Most Popular Parts
These are the most commonly purchased repair parts for CGS990SET4SS.
-
(3)
The oven door bumper is used to protect the exterior of the oven when the door is closed. By installing the door bumpers, it will prevent the drawer door from rubbing against the cabinet. If one breaks or goes missing you will need to replace the bumper. This part is black in color, made of rubber, and is sold individually. This is a genuine OEM part.
-
(2)
This is a replacement burner cap for your gas range or cooktop. The burner cap is found on the burner head, and prevents debris from getting into the head when it is not in use. The cap is black in color and is sold individually. It is a little more than 4 inches in diameter. To replace the burner cap, simply remove the damaged cap, and replace it with the new one. No tools are required for this repair. This is an OEM part from the manufacturer.
-
This knob accepts a D-shaped shaft. Sold individually.
NOTE: The manufacturer has updated this knob. It may be smaller than the original but will function the same.
-
This probe is used to check the internal temperature of the meat to ensure proper temperature is reached. Also known as a Meat Probe.
-
(2)
This part is the replacement oven burner igniter, broil igniter, or glow bar igniter for your cooktop or range. It is designed to ignite the fuel from the fuel lines and light the broil burner. If your broil burner will not ignite, it is a good indication that the burner igniter is burned out or damaged. Be sure to shut off the power and gas to the range before you begin to repair this part. This part is sold individually and is an OEM part from the manufacturer.
-
This is a replacement vision burner or surface burner head for your gas range. It is silver in color and approximately 4.5 inches in diameter. This burner is sold individually. The burner head distributes gas to create an even flame across the cooking area. If you notice that your food is not cooking evenly, or you are not getting an evenly distributed flame, you may need to replace the burner. The burner is located beneath the burner cap, below the grate. To remove the burner, simply remove the grate and the burner cap, then lift the burner head out. Replace it with the new burner, and reinstall the cap and grate. This is an OEM part sourced directly from the manufacturer.