Most Popular Parts
These are the most commonly purchased repair parts for DDE8200GBL.
-
(2)
This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.
-
(1)
This 10W - 120V light bulb is used on the inside of your dryer to provide light when the door is open. It is clear in color and has a standard screw-in base. If your current bulb is burnt out or broken you will need to replace it. This bulb is a genuine OEM part and is sold individually.
-
(2)
This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.
-
(1)
The idler pulley helps maintain the proper amount of tension on the drive belt to turn the drum. The idler pulley is located between the motor pulley and drum to provide tension on the belt. If the part has become worn, it could cause the dryer to be noisy or squeaky, and the pulley will need to be replaced. This part is yellow in color, made of plastic, and measures approximately 2 1/2” in diameter. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.
-
This screw is sold individually.
-
(1)
This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.