Admiral Dryer DE18F2HW Sections

There are 3 diagrams for DE18F2HW. Click on the diagram where you think your part is located.

CONTROL PANEL (REV. J)

CYLINDER & DRIVE (REV. J)

HEATER (REV. J)

Most Popular Parts

These are the most commonly purchased repair parts for DE18F2HW.

Multi Rib Belt - 92-1/4"

$16.00

In Stock

(42)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
Screw, 8/18 x 3/8

$7.40

In Stock

This screw is sold individually.
Screw

$12.18

In Stock

This screw is sold individually.
Blower Wheel Clamp

$12.67

In Stock

The blower wheel clamp is used to hold the blower wheel to the motor shaft. The clamp is less than an inch long and is used with your dryer. If your blower wheel is loose or making a noise while operating, you may need to replace the clamp. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.
Lint Duct Housing

$95.76

In Stock

(1)

Does not include the seal
Heating Element Kit - 240V 4750W

$60.87

In Stock

(2)

This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.