Admiral Dryer DG20F8AM Sections

There are 7 diagrams for DG20F8AM. Click on the diagram where you think your part is located.

CONTROL PANEL (REV. A - H)

CONTROL PANEL (REV. J)

CYLINDER & DRIVE (REV. A - H)

CYLINDER & DRIVE (REV. J)

EXTERIOR (REV. A - H)

GAS CARRYING

GAS CARRYING (REV. A - H)

Most Popular Parts

These are the most commonly purchased repair parts for DG20F8AM.

Multi Rib Belt - 92-1/4"

$16.18

In Stock

(42)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
M Series New Style Coil Kit

$29.07

In Stock

(7)

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
Dryer Radiant Flame Sensor

$42.18

In Stock

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.
Door Catch Kit

$27.00

In Stock

The door catch helps keep the door closed while the machine is running. If your dryer will not start or the door will not close you may need to replace the door catch. This is a genuine OEM part and includes both the male (strike) and female (catch) pieces. Please remember to disconnect the power to your dryer before you start the repair.
High Limit Kit

$31.07

In Stock

(1)

This kit comes with three separate thermal fuses and is usually used with clothes dryers that have a fan mounted on the motor shaft. Included within this kit is the high limit (Limit: 258), the gas high limit (Limit: 240), and the gas and electric high limit thermostat (Limit: 300).
Lint Filter

$48.87

In Stock

(3)

The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This lint filter screen has two side guides on either of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide. This is a genuine OEM part.