Most Popular Parts
These are the most commonly purchased repair parts for DU840SWPS2.
-
(18)
This gray rack track stop is used for your upper dish rack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.
-
(2)
If your dishwasher is leaking during use you may need to replace the gasket. The door gasket wraps around the sides and top of the dishwasher door and provides a waterproof seal between the tub and the door. It is gray in color and made of rubber. Once you have installed the door gasket it is recommend to close the dishwasher door and leave it closed for a few hours to make sure the door gasket properly seals. This is a genuine OEM part.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(3)
Sold Individually - 4 required on rack.
-
(3)
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. NOTE: As per the manufacture this part has been updated from the original part. It may be a different color, and you may need to order an elbow (# W10685193) for the new designed valve to work.
-
(4)