Most Popular Parts
These are the most commonly purchased repair parts for EIMED6CLSS3.
-
(3)
This 3-coil 5500 watts heating element with housing is used to produce heat to dry the clothes in your dryer. The heating element is strung with a coiled wired. The wire receives, but resists a controlled electric current causing the wire to heat up to dry your clothes. If there is no heat or it is taking too long to dry, you may need to replace the heating element. Check for a blown thermal fuse or thermal cut off. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.
-
-
(2)
This dryer drum drive motor with pulley for drum belt has reverse threads for the blower wheel. This is a genuine OEM part.
-
This is an authentic idler pulley, which works with dryers.
-
The two-terminal high limit thermostat has a limit of 260 degrees Fahrenheit and acts as a safety mechanism that keeps the dryer from overheating. The thermostat will cut out when the internal dryer temperature reaches 260 and then cuts back in when the temperature drops by 70 degrees Fahrenheit. If your dryer is not heating, you may need to replace the thermostat. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.
-
The dryer drum support roller with clip helps hold the drum in place while the drum rotates on the support wheels. Over time the bearings can wear out, causing them to make a squeaking sound while the dryer drum turns. The manufacturer recommends replacing both rollers at the same time. Please remember to disconnect the power to the dryer before starting this repair. This is an OEM part.