Most Popular Parts
These are the most commonly purchased repair parts for FEP320YW2.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(14)
The 2600 watt 240 volts bake element is located inside the oven on the bottom to supply heat while baking. This closed hinged style bake element is 15 3/4-inch long 16 5/8-inch wide, terminal depth is 3-inch and they are 1 3/4 inches apart. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
This 8” plug in style surface burner element provides heat to the cooking surface of your range. The burner element has looped terminal ends, 2600 watts, and a 5-turn. If the burner element is not heating it could be the element or the burner switch. You can use a multimeter to test the element or the switch for continuity. This is a genuine OEM part; the manufacturer recommends replacing the burner receptacle when you replace the surface burner element. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. This part is sold individually.
-
(3)
This standard Y-frame 6” surface element is a genuine OEM part that supplies heat to the cooking surface on your range. It has four turns, a black center medallion, looped terminal ends and carries 15000 tts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair. The manufacturer suggests replacing the receptacle at the same time.
-
(2)
This switch controls the stovetop surface burner.
This surface element control switch is for ranges.
Surface element control switch turns the surface element on and off and controls how much heat the element produces.
Unplug the range or shut off the house circuit breaker for the range before installing this part. Wear work gloves to protect your hands.
-
This switch controls the stove top 6" surface burner.