Most Popular Parts
These are the most commonly purchased repair parts for FES355YL0.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(14)
The 2600 watt 240 volts bake element is located inside the oven on the bottom to supply heat while baking. This closed hinged style bake element is 15 3/4-inch long 16 5/8-inch wide, terminal depth is 3-inch and they are 1 3/4 inches apart. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
(11)
This control switch controls the stove top 8" surface burner. 8.9- 11.0 amp. This surface burner element switch is for an 8-inch surface burner on an oven, stove, or range. The element switch controls the heat of the surface burner. Disconnect power to your range before completing this repair because you will be working closely with electrical circuits. Remove the screws from back panel and the console, and remove the console to expose the switch. It is recommended to check for overheating or arcing on the wiring harness in case they need to be replaced as well. The harness that connects to the switch features a slip-on terminal for easy installation.
-
This 8” plug in style surface burner element provides heat to the cooking surface of your range. The burner element has looped terminal ends, 2600 watts, and a 5-turn. If the burner element is not heating it could be the element or the burner switch. You can use a multimeter to test the element or the switch for continuity. This is a genuine OEM part; the manufacturer recommends replacing the burner receptacle when you replace the surface burner element. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. This part is sold individually.
-
(3)
This standard Y-frame 6” surface element is a genuine OEM part that supplies heat to the cooking surface on your range. It has four turns, a black center medallion, looped terminal ends and carries 15000 tts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair. The manufacturer suggests replacing the receptacle at the same time.