Most Popular Parts
These are the most commonly purchased repair parts for FES370VL0.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(7)
This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
This eight-inch chrome drip bowl is intended for use with rolled terminal style plug-in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
(8)
Please note: This is a substitute from the original part. It may physically look different, but will still function the same. This bake element is found on the bottom of the oven.
-
(2)
This surface burner heating element is six inches in diameter. It has four turns and looped terminal ends. This element provides heat to the cooking surface on your range. If your element is not heating, you may need to replace this part. Make sure the power has been disconnected and the element is turned off and cool before starting your repair. The element is a genuine OEM part. It is sold individually.
-
(2)
The broil element is located on the roof of the oven cavity to supply heat for broiling. The element measures approximately 13 1/2-inch wide,19-inch long and 3000 watts. If the broil element is no longer heating or it has shorted out, then you will need to replace your broil element. Please remember to disconnect the power to the oven before starting your repair. This is a genuine OEM part.