Frigidaire Freezer FFU14F5HWN
Repairing your FFU14F5HWN Frigidaire Freezer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
FFU14F5HWN model diagrams below. Trust us to help you find the part you need and get your
FFU14F5HWN Frigidaire Freezer running again.
Diagrams for Frigidaire FFU14F5HWN Freezer
There are 4 diagrams for FFU14F5HWN. Click on the diagram where you think your part is located.
Most Popular FFU14F5HWN Parts
These are the most commonly purchased repair parts for FFU14F5HWN.
-
(14)
The door gasket provides an air tight seal, between the door and the freezer, to keep warm air from entering. If your freezer is too warm, frost builds up, or the gasket is torn you may need to replace the door gasket because the freezer will need to work harder in order to cool down. This white door gasket is made of rubber and is a genuine OEM part.
-
(2)
The run capacitor is attached to the compressor. This part is 120 volts and 15 mfd. The run capacitor helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.
-
(6)
This white plastic freezer door key is used for most upright or chest freezers. If your door key becomes broken or lost it will need to be replaced. This is a genuine OEM part. It is sold individually.
-
(5)
The defrost thermostat snaps onto the top portion of the evaporator, it acts as a safety device and protects the evaporator from overheating during the defrost cycle. The thermostat can sense the rise in the evaporator temperature during the defrost cycle and cycles the defrost heater off after all the frost is melted from the coils. The defrost thermostat may need to be replaced if the appliance is experiencing temperature-related issues such as: too cold, too warm, frost buildup, not running, or running too long. This is a genuine OEM part. It is recommended to disconnect the power to your appliance before starting your repair.
-
(2)
User Control and Display - 115V - White
Used to control the temperature of the freezer. This electronic control board is for freezers.
Electronic control board manages the functions of the freezer such as the temperature settings and defrost cycle time.
Safely store any food that could deteriorate while the power is off and unplug the freezer before installing this part. Wear work gloves to protect your hands.
-
(2)
The 115-volt evaporator fan motor is in the back of the freezer section and circulates air over the coils. These coils will convert the heat into cool air, which is then circulated. If your freezer is noisy or too warm from the motor not working, you will need to replace this part. It is suggested to replace the thermistor when replacing the evaporator fan. This is a genuine OEM part – note the screw holes in the motor are not threaded from the factory, use your old screws. Please remember to disconnect the power to the refrigerator before starting your repair.