Most Popular Parts
These are the most commonly purchased repair parts for FRT21NNHD2.
-
(2)
This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(5)
The defrost thermostat snaps onto the top portion of the evaporator, it acts as a safety device and protects the evaporator from overheating during the defrost cycle. The thermostat can sense the rise in the evaporator temperature during the defrost cycle and cycles the defrost heater off after all the frost is melted from the coils. The defrost thermostat may need to be replaced if the appliance is experiencing temperature-related issues such as: too cold, too warm, frost buildup, not running, or running too long. This is a genuine OEM part. It is recommended to disconnect the power to your appliance before starting your repair.
-
If your refrigerator or freezer is too warm or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.
-
Sold individually.
-
(1)
The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.
-
This is the replacement crisper drawer cover support for your refrigerator. The crisper shelf rests on the support, which keeps it level. If your drawer cover or shelf will not stay level, or will not stay in place, the support may be damaged. The support is held in place on the refrigerator wall with a drive pin. To remove the damaged support, simply drive the pin all the way in, and use a putty knife to pry the support from the refrigerator wall. At this point, pull the drive pin out and replace the old support with the new one. This is an OEM part and is sold individually.