Most Popular Parts
These are the most commonly purchased repair parts for GC2225GEK9.
-
(2)
This water filter has been updated by the manufacturer. It may appear different but will still function the same. No tools are required to replace your water filter. It is sold individually. This water filter is a genuine OEM part and should be changed every 6 months.
-
(1)
This part turns on the light when the door is opened.
-
(3)
Bucket only.
-
(2)
This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.
-
This is a light switch for your refrigerator. It activates when the door of your appliance is opened, and it will turn the light inside on and off. You will need to replace this part is if your light is not working properly. In order to make this repair you will need a Phillips screwdriver, a pair of needle nose pliers, and a small flat blade screwdriver. This light switch is almost 2 inches long, 1.5 inches wide, and just over an inch thick.
-
This drip tray, also known as an overflow grille, is a manufacturer-approved replacement part for your refrigerator. The drip tray catches drips of water from the ice and water dispenser. To replace this part, simply pull out the existing overflow grille, and slide the new one into place.