Most Popular Parts
These are the most commonly purchased repair parts for GC2225PEKW.
-
(1)
This part turns on the light when the door is opened.
-
This screw is sold individually.
-
(2)
This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.
-
This is a light switch for your refrigerator. It activates when the door of your appliance is opened, and it will turn the light inside on and off. You will need to replace this part is if your light is not working properly. In order to make this repair you will need a Phillips screwdriver, a pair of needle nose pliers, and a small flat blade screwdriver. This light switch is almost 2 inches long, 1.5 inches wide, and just over an inch thick.
-
The ice bucket is used to hold the ice cubes in the freezer section that are released from the ice maker until ready to be used. If the bin becomes lost or damaged, you will need to replace the bin. The bin is white in color, made of plastic, and measures approximately 15” x 12”. This is a genuine OEM part.
-
(1)
This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.