Most Popular Parts
These are the most commonly purchased repair parts for GFS187/MN00.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.
-
(1)
The evaporator fan motor is in the back of the freezer section and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. It is suggested to replace the thermistor when replacing the evaporator fan. This kit comes with two mounting grommets, two sleeves (not to be used on porcelain models), two #8 mounting screws, and a push-on fan blade. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.
-
The cold control thermostat helps maintain the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process. If the refrigerator is too warm you may need to replace the control thermostat. This part has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.
-
-
The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.