Most Popular Parts
These are the most commonly purchased repair parts for GR440LXLC0.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
This temperature sensor detects the temperature within the oven cavity. This oven temperature sensor, for ranges, works together with the oven control board to measure and regulate the oven temperature. The sensor detects the temperature in the oven cavity. If the following symptoms occur, replacing the temperature sensor could be the solution: Little or no heat when baking, oven not heating evenly, oven will not start, and/or oven is overheating. Often, if the sensor is defective, the oven temperature will fluctuate and be inaccurate by more than 50 degrees. The tool needed for this replacement is a #2 square head screwdriver or a #2 Philips screwdriver. Remember to unplug the range before installing the part.
-
(10)
This Whirlpool OEM 2400-watt bake element has push-on terminals and is located on the bottom of the oven cavity. The bake element supplies heat while baking. If the oven is not heating properly the bake element may have burned out. If the element has burned out there would be visible damage such as holes, cracks, or blisters. When replacing the element, do not allow the wires to fall back through the rear of the oven. Disconnect the power to the range before starting your repair.
-
This switch controls the stove top 6" surface burner.
-
(3)
This broil element is found on the roof of the oven.
-
(2)
The large surface element is installed under the cooktop and heats up the area directly above it. It is approximately 10 inches in diameter and is 1200/2500 watts. If your element is not heating up, you may need to replace the element or check the burner switch. This part a genuine OEM part. Please remember to disconnect the power to your range before starting your repair.