Most Popular Parts
These are the most commonly purchased repair parts for GTDS570ED1WW.
-
(4)
This single white drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum will not tumble, you many need to replace the slides. The manufacturer recommends replacing both slides at the same time; there are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect power to the dryer before starting your repair.
-
(13)
This drive belt is about 89 1/2-inch long and has 4 ribs. This part is made to wrap around the drum, to rotate it. If your dryer drum will not turn, then you may need to replace your belt. It is recommended to disconnect the power to your dryer before you start your repair. This drive belt is a genuine OEM part.
-
The duct felt seal allows the front of the drum to glide smoothly on the exterior panel while the drum is rotating. The seal is located between the back of the drum and the rear dryer panel. If the heat is escaping from the drum area causing the dryer to run too long or if there are marks on your clothes you many need to replace the duct felt seal. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(2)
This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.
-
(5)
This part is on the outer door of the dryer.
-
(11)
The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry, the lint filter frame becomes damaged or the filter has torn you may need to replace the lint filter. The frame is white in color. This is a genuine OEM part.