Hotpoint Washer HSWP1000M4WW
Repairing your HSWP1000M4WW Hotpoint Washer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
HSWP1000M4WW model diagrams below. Trust us to help you find the part you need and get your
HSWP1000M4WW Hotpoint Washer running again.
Diagrams for Hotpoint HSWP1000M4WW Washer
There are 4 diagrams for HSWP1000M4WW. Click on the diagram where you think your part is located.
Most Popular HSWP1000M4WW Parts
These are the most commonly purchased repair parts for HSWP1000M4WW.
-
(10)
This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.
-
This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.
-
(13)
This plastic dual action agitator is white in color. It is approximately eighteen inches tall with a base diameter of about 12-1/4 inches. The agitator pivots back and forth, moving the clothes from the top to the bottom of the tub, through the detergent and water to wash them. If the agitator becomes damaged or will not agitate, you may need to replace the part. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(6)
This part is a replacement control knob for your washer. The control knob allows you to select the desired setting for your wash cycle. If your washer will not start or the timer will not advance, you may need to replace the control knob. Occasionally the control knob will become worn, and when this happens the control knob dial will not turn, and you will not be able to select the appropriate setting. If your control knob is worn, broken, or missing, you will need to replace it. The control knob is made of white plastic and is approximately 2 inches in diameter. The control knob is sold separately from the control knob dial, so be sure to confirm which part you need to complete your repair.
-
(3)
-
(1)
This timer is for washers.
The timer controls the electrical components and the duration of the washer's cycles.
Unplug the washer before installing this part. Wear work gloves to protect your hands.