Roper Ice Maker IMKIT94
Repairing your IMKIT94 Roper Ice Maker is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
IMKIT94 model diagrams below. Trust us to help you find the part you need and get your
IMKIT94 Roper Ice Maker running again.
Diagrams for Roper IMKIT94 Ice Maker
There are 1 diagrams for IMKIT94. Click on the diagram where you think your part is located.
Most Popular IMKIT94 Parts
These are the most commonly purchased repair parts for IMKIT94.
-
(4)
The single water inlet valve is used to supply water to the water dispenser and the ice maker. The valve is 60Hz 120 Volts and 35 watts. If your ice maker isn’t producing ice or the water dispenser not dispensing water, the solenoid might have gone bad and will need to be replaced. This valve includes 1/4” tubing and a plastic union. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the refrigerator before starting the repair.
-
(6)
This part is used to help tell the icemaker what to do - it turns the timing cams and the ejector blades. It also controls the heater, the water inlet valve, the cube size, and cube ejection. The control assembly is located under the white cover of the ice maker. If the ice maker is making too much ice or not making ice at all, you may need to replace the control assembly. The motor is not sold separately. This is a genuine OEM part. Please make sure you disconnect power to the refrigerator before starting your repair.
-
-
(1)
The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.
-
This bracket is used in conjunction with the ice maker.
-
(1)
This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.