Most Popular Parts
These are the most commonly purchased repair parts for JB250DF3BB.
-
(9)
The 8-inch surface element switch is also known as an infinite heat switch, and is a part for your range. It controls the large surface element. It will turn the element on and off, and allow you to change the heat intensity. The knob to adjust the heat setting mounts on the shaft of this swtich. The burner knob is sold separately. If your large surface element will not turn on, or you cannot adjust the heat intensity, you may have a broken or damaged surface burner switch. Be sure you disconnect your range from the power source before you begin this repair.
-
(13)
The bake element provides heat for baking and is located on the bottom of the oven. This part measures approximately 20-inch in length, 18-inch wide and is made of metal. If your bake element has shorted out, has arcing, makes the oven too hot, is not heating properly or has little to no heat, you may need to replace it. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. Please remember to disconnect the power before starting your repair. This is a genuine OEM bake element.
-
(1)
The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(8)
This part is also known as the "brains" of the appliance. ***NOTE: The wiring could be different than the original control. This part may need to be installed by an appliance repair person.
-
(7)
The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.
-
(1)
This switch controls the small burner on a range/stove top.