Most Popular Parts
These are the most commonly purchased repair parts for JBS02*P1.
-
(8)
This closed-hinged style bottom bake element is located on the bottom of the oven cavity to supply the heat for baking. This bake element has screw-on wire terminals is 18 1/4-inch wide and 14 1/2-inch deep to mounting flange and the terminal ends extend 2 1/2-inch past the flange. The element is 2300 watts and 20 volts. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
(6)
The broil element is located on the roof of the oven cavity to supply heat for broiling. The depth of the screw-on terminals is 2-3/4 inches and they are 1-1/4 inches apart. The mounting bracket is not included with the element. If the element is no longer heating or it has shorted out, then you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
This 6 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.
-
(1)
This 8 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.
-
(1)
The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.
-
This surface element kit includes an 8 inch element, two wire, 2350 watt surface element, and a terminal block with all three-wire units. These high rise elements do not come with an attached trim ring.