Most Popular Parts
These are the most commonly purchased repair parts for JCKP13GR2.
-
(3)
The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
-
(6)
This bake element is found on the bottom of the oven.
-
(3)
The broil element with push-on terminals is located on the roof of the oven cavity to supply heat for broiling. If the element is no longer heating or has shorted out, you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.
-
-
(1)
The oven bulb lens cover is made of glass and is approximately 2.75 inches in diameter. The lens cover protects the light bulb from being damaged. If the lens is cracked, damaged, or missing it will need to be replaced. It is suggested to make sure that the lens cover is cool to the touch before you start this repair. To remove the bulb lens cover simply slide the retaining clip off and then remove the lens. Replace it with a new cover and slide the retaining clip back on to hold it into place. This is an OEM part sourced from the manufacturer.