Most Popular Parts
These are the most commonly purchased repair parts for JDS27GL3.
-
(3)
The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
-
(1)
The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
The chrome drip bowl is located under the burner element to catch anything that may spill over to make cleaning up spills quick. This drip bowl is eight inches in size and is intended for use with rolled terminal style plug-in surface element units. This is a genuine OEM part and is sold individually.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.
-
(1)
The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.
-