Jenn-Air Range JGS8860BDP
Repairing your JGS8860BDP Jenn-Air Range is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
JGS8860BDP model diagrams below. Trust us to help you find the part you need and get your
JGS8860BDP Jenn-Air Range running again.
Diagrams for Jenn-Air JGS8860BDP Range
There are 9 diagrams for JGS8860BDP. Click on the diagram where you think your part is located.
Most Popular JGS8860BDP Parts
These are the most commonly purchased repair parts for JGS8860BDP.
-
(2)
This broil igniter assembly comes with its own metallic mounting bracket and an seven inch long dual wire lead with a plastic plug.
-
(1)
Sold individually. This knob accepts a D-shaped shaft.
-
(4)
This is the burner head and electrode for your gas range. If your gas igniter glows but will not light, or if the element will not start or heat entirely, you may need to replace the burner head. This burner head is approximately 4¼ inches in diameter and is sold individually. Please note that the mounting screws for this burner head are sold separately. To replace the burner head, simply unscrew the old, defective burner head and screw in the new one.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is 3 inches in length and is a genuine OEM part. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(5)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.
-
(3)
This part includes the spark igniter.