Most Popular Parts
These are the most commonly purchased repair parts for JKP27*08.
-
(20)
This 240-volt 3100 watt bake element has screw style connections, 13 1/4-inch wide by 163/4-inch long. The bake element is located on the bottom of the oven cavity and supplies the heat for baking. If your oven is not heating evenly, the element will not heat or there is little to no heat when baking, you may need to replace the element. This genuine OEM bake element comes with an instruction sheet and is intended for use with electric ovens. Please remember to disconnect the power to your range before you start your repair.
-
(8)
This closed-hinged style bottom bake element is located on the bottom of the oven cavity to supply the heat for baking. This bake element has screw-on wire terminals is 18 1/4-inch wide and 14 1/2-inch deep to mounting flange and the terminal ends extend 2 1/2-inch past the flange. The element is 2300 watts and 20 volts. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
(6)
The broil element is located on the roof of the oven cavity to supply heat for broiling. The depth of the screw-on terminals is 2-3/4 inches and they are 1-1/4 inches apart. The mounting bracket is not included with the element. If the element is no longer heating or it has shorted out, then you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(1)
This element has screw on terminals.
-
(1)
The oven bulb lens cover is made of glass and is approximately 2.75 inches in diameter. The lens cover protects the light bulb from being damaged. If the lens is cracked, damaged, or missing it will need to be replaced. It is suggested to make sure that the lens cover is cool to the touch before you start this repair. To remove the bulb lens cover simply slide the retaining clip off and then remove the lens. Replace it with a new cover and slide the retaining clip back on to hold it into place. This is an OEM part sourced from the manufacturer.
-
(1)