Most Popular Parts
These are the most commonly purchased repair parts for JKP85WA3WW.
-
(3)
The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
-
(3)
The broil element with push-on terminals is located on the roof of the oven cavity to supply heat for broiling. If the element is no longer heating or has shorted out, you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.
-
(2)
The line fuse, also known as a ceramic fuse, is used to protect your microwave when there is a power serge by shutting down the microwave to avoid damage. If your microwave has no heat, won’t turn on, or the touch pad is not working properly, you may need to replace the fuse. This part measures approximately 1.25” long and is sold individually. Please remember to disconnect power to the microwave before starting the repair. This is a genuine OEM part.
-
(4)
The secondary door switch, also known as a micro switch, works in conjunction with your microwave by monitoring the door latch position and sending communication to the electronic control board to let it know if the latch is open or closed. When the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, the switch has failed, and the part will need to be replaced. You can test the switch for continuity. This part measures 1.5” L x .75” W. Due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge, even when unplugged, it is suggested to have a service technician install the part. Please disconnect power to the microwave before beginning the repair. This is a genuine OEM part.
-
(1)
The door interlock switch (normally closed) works in conjunction with your microwave operation. The switch will prohibit the microwave from starting when the microwave door is open. If your microwave won’t turn on or there is no heat you may need to replace the switch. This part measures 1.5” L x .75” W, 250 volts, is black in color with a red dot and is sold individually. Please remember to disconnect the power before starting your repair. This is a genuine OEM part.