Most Popular Parts
These are the most commonly purchased repair parts for JSP26GN2.
-
(18)
This partially open-style bake element comes with ¼-inch push-on terminals and is located on the bottom of the oven. This bake element provides heat for baking. If your oven is too hot, not heating evenly, the element is not heating, or has little to no heat when baking, you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.
-
(3)
The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
-
(1)
The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(1)
The 8” coil surface burner element is used to supply heat to the top of the range for cooking. This element carries 2350 watts, and due to an update by the manufacturer is now a 5-turn element. If the element is not providing heat, the switch or element might have gone bad and will need to be replaced. You can use a multimeter to test for continuity to see which part is defective. Please make sure the element is cool before replacing it. This is a genuine OEM surface burner element. Disconnect the power to the range or cooktop before starting the repair.
-
This Y-frame 6-inch surface element is a genuine OEM part. It has five turns, a metallic center medallion and carries 240 volts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair.
-
(1)
This 8 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.