Most Popular Parts
These are the most commonly purchased repair parts for KEBS107SWH00.
-
(4)
This broil element is found on the roof of the oven. The broil element is at the top of the oven and supplies the heat to broiling. 14" x 15" with 1-3/8" inserts.
This part works with the following brands: Whirlpool, Roper, Admiral, Maytag, Hardwick, Jenn-Air, Estate, Magic Chef, Crosley, Inglis, Norge, Modern Maid, Amana, Kenmore, KitchenAid, Caloric.
-
(2)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(2)
The meat probe sensor is used to cook more accurately by checking the internal temperature of the meat to ensure proper temperature is reached during cooking. If the meat probe sensor shorts out it can cause the wrong information to the control board and the sensor will need to be replaced. This part is brown in color and approximately 25 inches. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(1)
This bake element is found on the bottom of the oven.
-
This 5-watt 12-volt halogen light bulb provides light in the oven cavity when the door is open or the switch is turned on. The light assembly is a little over 1” long. If the light is not coming on the bulb may be burnt out or the socket has failed and will need to be replaced. This is a genuine OEM part and is sold individually.