Most Popular Parts
These are the most commonly purchased repair parts for KSSS42FJW00.
-
(27)
This 8-cube ice maker is used to help produce ice for your refrigerator. The ice maker receives water from the water inlet valve and will freeze the water until ice cubes are formed. Once the water has been frozen the ice cubes will be ejected from the mold into the ice bucket and will refill with water to repeat the process until the ice bucket is full. This ice maker does not include the bail or shut off arm. You can reuse the arms for your old ice maker or you can also order them separately if required. It does come complete with flat and round plug wiring harness, the mounting hardware, and the instructions. The harness can be reused. This ice maker will not fit refrigerators that have the ice auger mounted on the door. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.
-
(7)
Door switch turns the light off when you close the door.
-
(7)
This genuine Whirlpool water filter is used in your refrigerator to help reduce contaminants that may be in your household water supply. The water filter measures 2 1/2” in diameter and 10 1/2” long and is in the filter housing inside of your refrigerator. It is recommended to replace the water filter every 6 months for best performance. This water filter will fit all Whirlpool and KitchenAid refrigerators with a water filter located in the base grill below the door. Also, for Kenmore models starting with 106. Filters for taste and odor, sediment, chlorine, lead.
-
(4)
This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.
-
(3)
This black water filter cap is located near the bottom kickplate.
-
(1)
This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.