Most Popular Parts
These are the most commonly purchased repair parts for LFX23961ST.
-
(2)
This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.
-
(10)
The light switch lights up the interior cabinet of the refrigerator or freezer when the door is opened. If you open the door and the light won’t come on, or the light is always on, you may need to replace the light switch. The switch is white in color and measures approximately 2 1/2”. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.
-
(6)
The guide rail, also known as a drawer slide rail, is a genuine OEM replacement part for the freezer section of your refrigerator. The rail attaches to the right side of the inside wall of your refrigerator to support the sliding crisper drawer. This slide rail supports the storage basket in your freezer, allowing you to slide it open with ease. If the rail is broken or the drawer is not sliding properly, you will need to replace the slide rail.
-
(2)
This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you notice an unpleasant taste in your water or it suddenly dispenses much slower, these are also common indications that a replacement is necessary. It filters sediment, dirt, rust, cysts, lead, mercury, and more. For proper use, operating pressure should be 30-120 PS, operating temperature should be 33-100 degrees Fahrenheit, with a flow rate of 0.5 gallons per minute. Installation is quick and easy and does not require the use of tools.
-
(1)
-
This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.