LG Refrigerator LFX28968ST
Repairing your LFX28968ST LG Refrigerator is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
LFX28968ST model diagrams below. Trust us to help you find the part you need and get your
LFX28968ST LG Refrigerator running again.
Diagrams for LG LFX28968ST Refrigerator
There are 7 diagrams for LFX28968ST. Click on the diagram where you think your part is located.
Most Popular LFX28968ST Parts
These are the most commonly purchased repair parts for LFX28968ST.
-
(4)
This door bin is for refrigerators.
Door bin attaches to the inside of the refrigerator door and typically holds jars and bottles.
-
(27)
This is a replacement mullion rail for your French door-style refrigerator. You will typically find the mullion rail on the left side refrigerator door. The mullion rail helps to keep the refrigerator door closed. If the door will not close properly or if you notice leaking on your floor, you may need to replace the door mullion. A faulty mullion can gather moisture, resulting in a leak. To replace the mullion, simply disconnect the old mullion from the wire harness and unscrew it. Re-attach the wire harness to the mullion and screw it back into place.
-
(9)
This door gasket is used to make an air-tight seal for the cabinet when the door is closed to prevent warm air from entering the refrigerator. The gasket is gray in color and made of rubber. If your refrigerator is too warm, has frost build up, or the gasket is torn, you may need to replace the door gasket because the refrigerator will need to work harder to cool down. This is a genuine OEM part.
-
(9)
This wiring harness is 20 pin and 3 pin. Replacement ice maker for LG refrigerators. The ice maker assembly contains the mold to form ice and the ejection controls to fill the ice storage bin. Unplug the unit before performing installation of the assembly.
-
(7)
-
(3)
This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities that can cause ill-tasting water or an unpleasant smell. It reduces sediment, dirt, rust, limescale, sand, and many other contaminants that can be harmful to your health and the life of your appliance. This filter should be replaced every 6 months or 200 gallons to ensure top quality performance.
To remove your unwanted filter, press the push button to open the filter cover (water may spill from the hole), pull out the old cartridge in a downward motion. To install the new filter, make it so the ears are in the horizontal position and push the new cartridge into the housing until it stops. Push the filter upward until it is secure. Click the cover to lock it in place. Run water for approximately 5 minutes to prep the filter for use, and discard water. Reset the “filter reset” button if applicable.