Most Popular Parts
These are the most commonly purchased repair parts for LMV1683ST.
-
(6)
This 30 watt 120 volt incandescent light bulb, with a small screw base is used to light up the surface below your microwave or brighten the interior of the microwave once the door has been opened. If your light bulb is burnt out it will need to be replaced. Before you change the bulb, be sure to check that the light socket still works, as it may need to be replaced as well. Remember to disconnect the power to the microwave before you begin this repair. This is a genuine OEM part and is sold individually.
-
(3)
This mounting plate is a manufacturer-approved replacement part for your microwave. The mounting plate, or bracket, secures your above-range microwave in place against the wall. To conduct this repair, make sure to first disconnect the power source, and wear protective gloves.
-
This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.
-
(1)
The vent damper is used to close off the exhaust duct when the fan is not running, to prevent outside air from entering the microwave. When the fan turns on it allows air to vent away from the microwave. The damper measures approximately 10-inch long by 3-inchwide and is a genuine OEM part.
-
This bracket holds the metal or plastic flapper that closes off the exhaust duct when the fan is not running and opens when the fan turns on. If the exhaust fan on your microwave does not appear to be working, the problem may be with the damper assembly. If the damper does not open and close easily, check for any damage to the bracket, and replace if it is damaged or faulty. This genuine OEM exhaust damper measures approximately 12 inches long by 5 inches wide.
-
(1)