Most Popular Parts
These are the most commonly purchased repair parts for LMV2083SW.
-
(6)
This 30 watt 120 volt incandescent light bulb, with a small screw base is used to light up the surface below your microwave or brighten the interior of the microwave once the door has been opened. If your light bulb is burnt out it will need to be replaced. Before you change the bulb, be sure to check that the light socket still works, as it may need to be replaced as well. Remember to disconnect the power to the microwave before you begin this repair. This is a genuine OEM part and is sold individually.
-
(1)
This is an authentic LG charcoal filter for your microwave, sourced directly from the manufacturer. It is designed to remove odors from the air that circulate through your microwave vent. It measures approximately 11 inches in length, and 2.5 inches in width.
-
This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.
-
This genuine OEM light socket provides power to the light bulb in your microwave while holding it in place. This light socket is two pronged and the bulb should screw easily into it. If your light bulb will not light, check the bulb itself and light socket’s connection. If the socket is broken, or faulty it should be replaced immediately. Make sure to remove the high-voltage capacitor from your microwave before beginning this repair.
-
This line fuse protects the microwave by shutting down if there is an electrical surge. If your microwave is not turning on, you may need to replace the fuse. This part is just over an inch long, metallic on both ends and white ceramic in the middle. Please remember to disconnect power to your microwave before starting your repair. This is a genuine OEM part.
-
This part is used to generate microwave energy/heat.