Most Popular Parts
These are the most commonly purchased repair parts for LSC27950SW.
-
(2)
This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you notice an unpleasant taste in your water or it suddenly dispenses much slower, these are also common indications that a replacement is necessary. It filters sediment, dirt, rust, cysts, lead, mercury, and more. For proper use, operating pressure should be 30-120 PS, operating temperature should be 33-100 degrees Fahrenheit, with a flow rate of 0.5 gallons per minute. Installation is quick and easy and does not require the use of tools.
-
-
(2)
This is an authentic OEM part sourced directly from the manufacturer. The crisper slide rail for your refrigerator allows the crisper drawer to slide in and out, and supports the drawer as it does so. This part is for the right side of your crisper drawer. Please note that the roller for this guide rail is a separate part under part number PS11759956.
-
(2)
The wire harness is NOT available separately. Refrigerator ice maker kit AEQ36756901 is an original equipment manufacturer (OEM) part that fits some refrigerators in these series: Kenmore 795; Kenmore Elite 795; and LG LFX, LMX and LSC.
Ice maker AEQ36756901 receives water from the water inlet, holds the water in the ice mold until the water freezes solid and then automatically ejects the ice and refills to continue the process until the ice storage in is full.
This ice maker kit contains the complete ice maker, housing and control device.
-
This part is the replacement push switch for your refrigerator. It is made of white plastic and is sold individually. The door switch turns the light on and off when you open the door, and it is also a safety mechanism that doesn’t allow the auger motor to come on and dispense ice when the door is open. To remove the switch, simply pry it out of position with a small flat head screwdriver, then disconnect the wires. Reconnect the wires to a new switch and snap it into place. Be sure to connect the wires to the switch in the correct order. This part is an authentic OEM part sourced directly from the manufacturer.
-
