Most Popular Parts
These are the most commonly purchased repair parts for LWA30AL.
-
This screw is sold individually.
-
This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.
-
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
-
(2)
This v-shaped spin belt helps transfer power from the motor to the transmission to help pump the water in and out of the washer. It also helps runs the spin cycle in the washer.
-
This wheel has a center metallic bearing. A dryer's idler pulley wheel serves to help the belt to rotate the drum.
-
This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.