Most Popular Parts
These are the most commonly purchased repair parts for MDB662RBR0.
-
This is sold individually. Please order quantity required.
-
The dishrack support roller attaches to the inside of the tub by a screw, to help support the upper rack. There are eight total inside the tub, four on each side. This support roller is made of plastic and is approximately 1 1/2” in diameter. The screw is not included with the roller, you can reuse the existing screw. This is a genuine part and is sold individually.
-
(2)
The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.
-
Sold Individually. Order quantity required.
-
NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.
-
This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into specific groups. This silverware holder is made entirely of plastic with a crisscross pattern allowing water and small food particles to pass through it during the cleaning process. This model is grey and roughly 14 inches long, about 6 inches high, and almost 4 inches thick.