Most Popular Parts
These are the most commonly purchased repair parts for MDE9700AYW.
-
This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.
-
This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.
-
(1)
This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.
-
(1)
This part is the replacement thermal fuse for your dryer. When you order this part, you will receive the fuse itself, as well as the bracket that mounts it to the dryer. The thermal fuse is approximately 2 inches wide from end to end. It is a safety device inside the dryer that shorts out if the dryer overheats. When the fuse shorts out, the dryer will function properly. You can test your thermal fuse for continuity using a multimeter. Be sure to disconnect your dryer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.
-
This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.
-
This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. The element will kick back in when the temperature drops to 210 degrees Fahrenheit - the differential of 50 degrees.