Most Popular Parts
These are the most commonly purchased repair parts for MNSR1070D5WW.
-
This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.
-
(10)
This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.
-
(2)
The tub seal helps prevent any leaking around the transmission of your washer outer tub. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. It is suggested to have it installed by a qualified technician because the seal can be difficult to replace. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(4)
This drain pump motor helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking, or pumps but will not spin, you may need to replace the drain pump motor. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(1)
This part is the replacement inner tub base hub for your washer. It is made of metal and is approximately 15 inches in diameter. The inner tub base hub fits between the wash tub and the spin basket, and it holds the spin basket on the gear case shaft. The main reason you would want to replace the hub, is if the washer will not agitate, or if you notice excessive noise or shaking when the washer is in use. Be sure to disconnect the washer from the water and power sources before you begin this repair. This part is sold individually and is and OEM part from the manufacturer.
-
(1)
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.