Most Popular Parts
These are the most commonly purchased repair parts for OEMMAYCONV9.
-
(2)
This top burner igniter has a male spade terminal. It is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start, or the gas igniter glows but will not light, you may need to replace the igniter. This is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.
-
(2)
This thermostat knob is two inches in diameter. It is made of plastic, and will accept a 'D' shaped shaft. This white knob has gray lettering along the perimeter denoting the temperature level as well as the off, broil, and warm positions.
-
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
-
(2)
This burner cap assembly is sold with the spark electrode. Please note this part has been redesigned and no longer requires a gasket. Sold individually.
-
This is a genuine OEM part that is used inside your range/oven to provide a durable surface for your cookware. The rack measures approximately 23 inches wide and 16 inches deep. The part is made of metal and is sold individually.
-
(10)
The flat style gas oven igniter is used to ignite the gas to light the oven burner, which produces heat for your range. If the element has shorted out, is no longer glowing, or is glowing but only orange or red rather than white, then you will need to replace the oven igniter. When replacing the igniter please be very careful not to touch the gray element part of the igniter as it is very fragile. The igniter measures approximately 3-3/4"in length and the amperage range is 3.3 to 3.6. This igniter kit can replace igniters for either the broil or bake burners and can replace shorter and longer igniters. The kit includes the igniter, 4 wire nuts, insulation, 2 wire assembly and a bracket. This is a genuine OEM part. Please make sure to disconnect the power and shut off the gas supply before starting your repair.