Most Popular Parts
These are the most commonly purchased repair parts for PC2S920EEJ3ES.
-
(3)
The oven door bumper is used to protect the exterior of the oven when the door is closed. By installing the door bumpers, it will prevent the drawer door from rubbing against the cabinet. If one breaks or goes missing you will need to replace the bumper. This part is black in color, made of rubber, and is sold individually. This is a genuine OEM part.
-
(7)
The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.
-
(3)
This surface burner head is for ranges.
Surface burner head distributes the gas through holes or slots to create an even flame across the cooking area.
Shut off the gas supply and unplug the range before installing this part. Wear work gloves to protect your hands.
-
(3)
The burner cap sits on top of the burner base and acts as a cover for the burner head. It helps protect the burner head from spills and helps spread the burner flame for even cooking. It is black in color and just over 3 inches in diameter. If your old burner cap is damaged or missing, this is the part that will replace it. This is an OEM part sourced directly from the manufacturer and is sold individually.
-
(3)
This broil element is found on the roof of the oven.
-
This part is the replacement surface burner head for your gas range. It is silver in color and is approximately 3.5 inches in diameter. This burner is sold individually. The burner head distributes gas to create an even flame across the cooking area. If you notice that your food is not cooking evenly, or you are not getting an evenly distributed flame, you may need to replace the burner. The burner is located beneath the burner cap, below the grate. To remove the burner, simply remove the grate and the burner cap, then lift the burner head out. Replace it with the new burner and reinstall the cap and grate. This is an OEM part sourced directly from the manufacturer.